Wave W.H.A.M.! Tetsukyojin from Panzer World Galient: Crest of Iron

Submitted by JoshB on 30 April, 2009 - 08:51.

This high end action model of the updated main mecha from Panzer World Galient looks beautiful, but does not come cheap. The Tetsukyojin is made out of ABS, PVC and Diecast and stands 23cm tall. The figure is mostly plastic with diecast used in the joint structure.

Like most of the Wave W.H.A.M. line, this seems way overpriced at a whopping 23,500 yen. I think I will stick to the CM's version, than you very much.

Due out in October 2009 from WAVE.



Source: http://www.1999.co.jp/eng/10089087

More: |
Link: Post page to del.icio.us | Digg this

login or register to post comments | Feed for comments on this post
diecast
apex3's picture
Submitted by apex3 on 30 April, 2009 - 09:32.

do you know where you got your diecast info??
because a guy selling the pre-order said he beieved it had the same diecast content as the macross carrier by same company,,,and it was 60-80% diecast



login or register to post comments
The english version of the
JoshB's picture
Submitted by JoshB on 30 April, 2009 - 09:50.

The english version of the hobbysearch llisting says:

"ABS on the basis, PVC alloys used in addition to strategic points, and positively Tetsukyojin appropriate to call the entire contents of the edition."

I took "alloys used in addition to strategic points" to mean diecast in the joints, but I could be wrong. will update as i know more.

------------------------------
CollectionDX Admin



login or register to post comments
thanks
apex3's picture
Submitted by apex3 on 30 April, 2009 - 10:01.

That is one of the things I hate most about collecting and co. descriptions, some make no sense...like takaratomy. Optimus prime all most all die cast...then megatron, etc.. all most none.



login or register to post comments
Didn't CM's already do a
Shogundan's picture
Submitted by Shogundan on 30 April, 2009 - 10:13.

Didn't CM's already do a nice version on this figure. Is it just me or does it make anyone else sick that the same figure is being produced over again by different manufacturers. This is just like what has been done with Dragonar and Patlabor's Ingram. LETS SEE SOME DIFFERENT MECHA!!!

-Dan
CollectionDX LLC
Vice President/Co-Owner
"the other fat bearded guy at CDX"



login or register to post comments
yeah
apex3's picture
Submitted by apex3 on 30 April, 2009 - 10:26.

but CM's figure was 6 inches tall, alittle too small for my taste, but a plastic figure for 250 is alittle ridiculous



login or register to post comments